ASTM C0241_C0241M-21

< div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.1< / span>  This test method covers the determination of abrasion resistance of all types of stones for floors, steps, and similar uses where the wear is caused by foot traffic.

< / div> < div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.2< / span>  The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

< div class=" SectionLevel3" > < p class=" subsec2 cdone2" > < span class=" Head4 cdone" > 1.2.1< / span>  < span class=" Head4Title cdone" > Exception—< / span> The formula for calculation of the result of this test method relies on the use of SI units all measurements of weight in this test method shall be recorded in SI units. See < span class=" Body-link1 cdone" > 10.1< / span> and < span class=" Body-link1 cdone" > 11.1< / span> .

< / div> < / div> < div class=" SectionLevel2" > < p class=" caveat cdone2" > < span class=" Head3 cdone" > 1.3< / span>  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

< / div> < div class=" SectionLevel2" > < p class=" WTOcaveat cdone2" > < span class=" Head3 cdone" > 1.4< / span>  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

< / div>